Furuno 2127 Bedienungsanleitung PDF herunterladen (Seite 29)

2. WIRING

2-5

11. Set the transceiver module to the antenna unit, push it in until it stops, and then tighten

fixing bolts (4 pcs.). Connect plugs P823, P803, P831, P921 and J911 (if installed).

Fasten the shield wire to the wing nut on the transceiver module.

CAUTION

Push in transceiver unit until it stops.

Failure to do so may cause leakage of

microwaves.

03P9349

Bow mark

Connector

plug

Clamp for

coaxial cable

Connect coaxial cable here.

Signal cable

Cable clamp for

antenna cable

Transceiver module

Connect shield wire to with wing

nut at the opposite side of the

transceiver module.

Antenna unit, front view

12. Confirm that all screws are tightened and all wiring is properly made. Confirm that

waterproofing gasket, bolts and tapping holes of antenna unit are coated with silicone

grease. Close the antenna unit cover (torque: 2.5 N·m).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 135 136

Keine Kommentare

Furuno 2127 Bedienungsanleitung Seite 29