Furuno 2127 Bedienungsanleitung PDF herunterladen (Seite 27)

2. WIRING

2-3

Antenna unit, front view, cover removed

6. Fabricate the signal cable RW-9600

as shown below.

a) Remove the outer vinyl sheath, by

about 500 mm, then armor and

inner sheath by about 470mm.

b) Unravel the shield to expose the

core wires.

c) Trim each core wire (except

coaxial wire) considering its

location on the terminal board.

d) Trim the shield leaving about 500

mm and attach crimp-on lug

FV5.5-4 (yellow,

I4).

e) Remove insulation of each wire by

about 6 mm.

7. Slide a washer, and fold back armor.

Slide a washer, rubber gasket,

washer, and clamping ring in order.

Cut the armor around the washer so

it is level with the washer.

Vinyl sheath

Shield

500mm

Shield

Fold back shield.

Conductor

14 5 9

Coaxial cable

30mm

Shield

Armor sheath

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 135 136

Keine Kommentare

Furuno 2127 Bedienungsanleitung Seite 27